FL-HST Polyolefin Heat Shrink Tubing

Colored Polyolefin Heat Shrink Tubes
Assorted Heat Shrink Tubing Sizes

Description

Wire insulation and joint protection

FL-HST tubing is made from irradiated cross-linked polyolefin for electrical insulation, harness identification, joint protection and strain relief. Select a supplied bore that fits over the component and a recovered bore suited to the finished assembly.

  • Operating temperature: -55°C to +125°C.
  • Minimum shrink temperature: +70°C; full recovery at +110°C.
  • Dielectric strength: at least 15kV/mm.
  • Flame-retardant VW-1 and halogen-free options are available.
  • Shrink-ratio options: 2:1, 3:1 and 4:1. The dimensions below apply to the listed 2:1 models.

2:1 model dimensions

All dimensions are in mm. Recovered D1 is the bore diameter; recovered D2 is wall thickness.

ModelSupplied boreSupplied wall thicknessRecovered D1Recovered D2
FL-HST-11.00.2±0.050.50.4±0.05
FL-HST-1.51.50.75
FL-HST-22.00.25±0.051.00.45±0.1
FL-HST-2.52.51.25
FL-HST-33.01.5
FL-HST-3.53.51.75
FL-HST-44.02.0
FL-HST-55.00.35±0.052.50.55±0.1
FL-HST-66.03.0
FL-HST-77.03.5
FL-HST-88.04.0
FL-HST-99.04.5
FL-HST-1010.05.00.60±0.1
FL-HST-1111.05.5
FL-HST-1212.00.35±0.16.00.70±0.1
FL-HST-1313.06.5
FL-HST-1414.07.0

Additional sizes and shrink ratios are available. Higher-ratio options require their own dimensional selection.