TB01-2DJ/3.5 terminal connectors provide push-in spring connections at a 3.5mm pitch. Select a 2–24-pole configuration and use the electrical rating associated with the applicable IEC condition or UL use group. The connector has a PA66 insulating housing and tin-plated brass contacts.
| Parameter | TB01-2DJ/3.5 |
|---|---|
| Pitch | 3.5mm |
| Number of poles | 2–24 |
| Connection rows | 1 |
| Wire connection | Push-in spring |
| Solid conductor cross section | 0.2–1.5mm² |
| Flexible conductor cross section | 0.2–1.5mm² |
| Flexible conductor with ferrule | 0.2–1.5mm² |
| Stripping length | 7–8mm |
The rated current is 7A. Rated voltage and impulse voltage depend on overvoltage category and pollution degree as shown below. A dash denotes an unspecified value.
| Overvoltage category | Pollution degree | Rated current | Rated voltage | Rated impulse voltage |
|---|---|---|---|---|
| III | 3 | 7A | — | — |
| 2 | 200V | 2.5kV | ||
| II | 320V |
| Use group | Rated current | Rated voltage | Wire range |
|---|---|---|---|
| B | 8A | 300V | 28–16AWG |
| C | — | — | — |
| D | 10A | 300V | 28–16AWG |
The AWG range and metric conductor cross sections are separate specifications. The 10A value applies to UL use group D; it does not replace the 7A IEC rating or the 8A UL group B rating.
| Property | Specification |
|---|---|
| Insulation material | PA66 |
| Insulation material group | I |
| Insulation flammability grade | UL94V-0 |
| Contact material | Brass |
| Contact finish | Tin plated |
| Protection level | IP20 |
| Operating temperature | -40°C to +105°C |
Specify TB01-2DJ/3.5 and the required pole count. Match the connector interface, keying and mounting arrangement to the intended counterpart; the 3.5mm pitch alone does not establish mating compatibility. Overall dimensions, a dimensioned PCB footprint and a specific mating part number are not specified.
